Grease Duct Light Test

Noncombustibility fire resistance durability internal fire and fire engulfment with a through penetration fire stop.

Grease duct light test.

The test involves passage of a light with not less than 100 watts through the entire section of ductwork to be tested listed ducts are exempt from this requirement. 1 blower with speed control vfd to generate range of pressure flowrange of pressure flow 2 flow measuring devices flow grid flow station high flow flow grid flow station high flow orifice plate low flow. 1 1 these test methods evaluate the enclosure materials and the grease duct enclosure systems using the following test methods. 4 1 5 a fire engulfment test uses a standardized fire exposure the time temperature curve of test methods e 119 to simulate a fire occurring on the outside of the grease duct and demonstrates the ability of the grease duct enclosure system to remain intact without a through opening.

Duct leakage test system consists of duct leakage test system consists of. Outside should be dark enough so u can hardly see things than turn on the light in the duct and move it so you are sure that every angle is ok. The fire engulfment test also tests the fastening methods. The permit holder shall be responsible to provide the necessary equipment and perform the grease duct leakage test.

Work lighting and other factors. Light test for duct leakage is the most common test and very authentic but there is a procedure to take into the consideration. Dont forget to check the duct from above as well since many inspectors check ducts from side and below. A light test shall be performed by passing a lamp having a power rating of not less than 100 watts or 1500 lumens for energy.

A light test or approved equivalent test method shall be performed to determine that all welded and brazed joints are liquid tight. A light test shall be performed by passing a lamp having a power rating of not less than 100 watts.